I have taken the image above from BS ISO 1101 (the gtol section of BS 8888), as it says "8.3 If the tolerance frame can be directly connected with the datum feature by a leader line, the datum letter may be omitted".
I wish to do this as above in Pro/Engineer but cannot seem to work out how it is done. I can only seem to show the datum with a letter and the gtol referencing that letter. It is the only time I want to refer to that surface and it is only in one view and so I would rather show it as above.
Anyone know how this can be done? I am using Wildfire 2.0.
Thanks.
