Geometry needed to orient the cross-secti

[florinfaur]

Hi everybody,

In a drawing of an assembly I've got an error message:
Geometry needed to orient the cross-sectional view "new_view_5", on sheet 1, is missing.
Everything looks good, but I would like to get ride of that message.
I couldn't find anything that would give me the possibility to orient in some way the cross-sectional view.

Thank your for your time.

Florin

 

[csusie]

This must have happened due to a reference being deleted that was used to orient that view. You could create a new saved view in that exact orientation and then change the view props to use that new view you just created instead of the old outdated reference view.

 

[SRINIVASANIYER1]

I find referencing Datum planes rather than geometric entities better. Other users may express their views.