Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.
Check the projection & alignment. If the view position is constrained to another view you will have to break the constraint. Delete the alignment or if it is projected change to general.
Yes, they highlight, I can delete them, just can't move them. The move special does not work either, nor does changing the position from the view properties.
I can move the views in one direction by aligning to another view that is outside the printable area, but if I remove the alignment the view jumps back to its original position. Very strange.
I have not tried a "view info", and I can't now because I've deleted the views. I decided to tackle the BOM problem instead, and managed to sort it out this way.
I would still be interested in a solution because it might do the same thing again on a view that I've invested a lot of time in.
Hello, Sam, You can try to creat one new section view, the general section view. Then try to move them. If you success, you can delete the old section view.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
