PDF creation

[Geneg]

I wonder if anybody can advise how to configure PDF creation in W2 using PTC


default icons.





Thanks,

 

[deepakbhat_nie]

HI,


I am not very sure whether I understood your question right. well if you want to create a pdf file output then you can go with print to a file option(in print command). and acheive it.


Regards,


Deepak Bhat

 

[Geneg]

I am getting A size PDF from C size original drawing, and I just wonder how to configure PDF output in order it will be exactly as a drawing.


Any suggestions?

 

[trillicomm]

do you want to print PDF in A size?

 

[trillicomm]

hit Print
hit Configure
choose A

 

[Geneg]

I do want to print b size on b size and c size on b size. But I do need fu;; viewa with formats.


I am getting only partual views of my drawings.


WhenI click on default PDF creation, there is no configuration options at all.
Edited by: Geneg

 

[trillicomm]

have to fully display the drawing view
go to File, Print, you will see Configure.

don't use the default PDF button

 

[grbala]

Hey Geneg,


to get full view of the drawing in PDF, give offset x,y value in the print configuration like in the below shown picture.


still if you don't get - reduce the scale with full plot option under model.(ref picture)


when you print "B" size on B-size, say scale value of .95


& for printing "C" size on B-size say scale value of .98


View attachment 3131

 

[slashct]

Also under options on the printer after you hit OK on the Print box make sure the paper size is set there. I have seen it where it defaults to A and the distiller only creates part of it on an A size.