saving to WF4 from WF5

[sip]

Hi all,


Inadvertantly I started a project in WF5, but noticed that I can't use Edrawings there yet. Using ATB how do I save back to WF4? My models are simple, and I don't have a lot of them yet, but it would save me a few days.


TIA


Sip

 

[jeff4136]

Sounds like one for product support.
WF5 is still pre-production?


Anyway, I think
http://www.ptc.com/products/granite/gcri/
is where I'd start looking otherwise.

 

[sip]

Thanks, Jeff


I think I'll end up remodeling. Less time than trying to figure this out. And yes, WF5 is still pp.


Sip

 

[kdem]

There is a GCRI for Pro/Engineer WF5 to WF3 and WF4.A link is located on the PTC site under Resource Center>Free Downloads. On the left of the page there is a section Related Resources with a link to GCRI Downloads if you want to check that.

 

[rajendran]

But, GCRI support only part and assemblies. Drawings, layout & mfg model are not supported.

 

[html26]

Hi all,


Inadvertantly I started a project in WF5, but noticed that I can't use Edrawings there yet. Using ATB how do I save back to WF4? My models are simple, and I don't have a lot of them yet, but it would save me a few days.


TIA


Sip

I also saw that eDrawing menu doesn't exist on wildfire5. I re-install proengineer but problem persists. is it a compatibility problem?
for w4 itwas working ok even I move from a buil to another.