simplify representation is it possible

[fisa]

hello every body


i want to use simplify representation in drawing for a single part to show the different stages of part modeling.but how idont know .in assembly this is very easy to do but for single part.............can any one guide me very thanks in advance





fisa

 

[Jonathan21409]

right click in the drawing and go to properties then drawing models and select set/add rep and you should be able to pick the rep you want and it will show up if you add a new drawing view after that.


If that doesn't work then try adding the model again and it should allow you to chose the other rep when you add it again into the drawing.

 

[Zestje]

Note that simplified reps were in WF1, but NOT in WF2 and then back again in WF3!


If you are on WF2 and need to edit a WF1 single part drawing with simplified reps you're basically (censored)

. I don't know how to handle the problem (luckily I haven't had the need to do that so far)...

 

[jelston]

Just some bought wisdom. If you are going to be ballooning these items, you may want to give some serious consideration to using layers instead of simplified reps. With simplified reps, only one simplified rep can drive the BOM balloons, so you won't be able to use parametric balloons on the other reps.

 

[fisa]

thanksevery one for reply my question.i have find the solution of my probllem from the pervious post about simp rep





thaks

Edited by: fisa

 

[fisa]

thanks every one for reply my question.i have find the solution of my problem from pervious post about simp rep.


thanks


fisa

 

[SRINIVASANIYER1]

Why dont you share thelink to that solution?


It will be easy for any future searches...

 

[jeff4136]

> If you are on WF2 and need to edit a WF1
> single part drawing with simplified reps


mapkey <key sequence> #VIEWS; #REPRESENT;