X-Section Spacing

[AGaribay]

Are there Config
or Drawing Options to set the X-Section Spacing? With hundreds of
components in my numerous assembly drawings, I would rather not change each
component individually. YIKES!

If not, can you set the X-Section in the PART model so
that whenever the part is X-Hatched in a drawing it would stay at the
setting?

Wildfire 2

 

[deepakbhat_nie]

Hi,


Yes you can acheive your requirement.Just follow the steps.


Add 2 parameters in the part


default_xhatch_spacing<real number<Spacing value


default_xhatch_angle<real number<hatch angle


If you want to use the same values in all the part then makesure that these two parameters is added in the start part.


now if you create the section then it will take the angle and spacing from the parameter you have defined in the part.


Regards,


Deepak Bhat

 

[dewster35]

How do you set the x-section spacing at the assembly level? Several components.